Check manual page of multipath

multipath

Author: Mathias Kettner

License: GPL

Distribution: official part of Check_MK

Supported Agents: Linux

This check monitors the state of multipath devices on Linux hosts. For each multipath device at time of inventory the number of paths is put into the check parameters. If later the number of paths is less then expected, the check goes critical. So it does if any of the paths is broken.

If the number of paths is higher than expected, the check goes warning. A reinventory of the check might be neccessary in that case.

This check is based on the output of the command multipath -l as sent by the Linux agent. It correctly deals with various subtle differences between the available versions of the multipath tools.

Item

The UUID of the multipath device, e.g. "360a980004334644d654a364469555a76". If the multipath device has an alias you can alternatively specify the alias as item.

Check parameters

Parameter	Type	Description
numpaths	int	The only parameter is the number of expected paths. This is not a tuple but a simple integer value.

Performance data

None.

Inventory

One check for each multipath device is created.

Configuration variables

None.